The LokPilot V3.0 M4 was developed from scratch especially for Märklin® systems.
(Not for NMRA DCC use.)

Operational modes
The LokPilot V3.0 M4 is a genuine multi-protocol decoder: Besides its main field of application in combination with mfx® stations, it handles Motorola® command stations (e.g. Märklin® 6021) as well as conventional AC driven layouts. The LokPilot V3.0 M4 recognizes the operational mode fully automatically and converts on the fly. Motor management

The LokPilot V3.0 M4 runs DC – and coreless motors directly, while all-current motors need a Hamo-magnet retrofit. The motor is driven by 40 kHz Pulse width frequency (PWM) for a super silent, safe run. Together with the 128 mfx® speed steps and fourth generation back EMF, unprecedented performance is realized.

Analog operation
The LokPilot V3.0 M4 also operates on analog AC layouts, on which even starter – and top speed can be limited individually. At last you can slow down your old high-speed runners.

Functions
The LokPilot V3.0 M4 sports four function outputs, which can be dimmed, and allocated individually to a function. Besides beacon, strobe and alternate flashing, there is a Mars light as well as a Gyra light.

Programming
The LokPilot V3.0 M4 can be adapted to any loco or operational mode. For this, you can comfortably change parameters with the systems-stations – during operation and without having to open the loco or put it on a programming track. That’s made possible through the built-in, genuine Duplex communication between systems-center station and decoder. For owners of 6020®, 6021® – or delta® stations the LokPilot V3.0 M4 decoder utilises the time-proven, simple programming procedure.

Safeguard
All function outputs and the motor connection are overload – and short circuit protected.

Built-in future
The internal decoder software can be replaced by a new firmware update, if desired.

Operational modes: M4 with 128 speed steps
Digital Motorola® (old and new) with 14 or 28 speed steps, up to 255 addresses in Motorola® use
Analog AC (de-selectable)
Automatic recognition of operational mode
Supports Märklin® braking section. Wrong-direction bit.
Intelligent programming mode with Märklin® 6021®
Switching speed and acceleration as well as deceleration key selectable

Throttle: 1.1 A continuous load
Runs DC, coreless and AC motors (with permanent magnet)
Silent, safe 16 / 32 kHz pulse width frequency motor regulation
Motor output overload protected. Fourth generation back EMF (de-selectable)

Function output: 4 outputs, 2 of which for lighting
250mA load per output
500mA total load of all function outputs. Overload protected.
Outputs short circuit protected (function mapping)

Dimensions: 23.5mm x 15.5mm x 5.5mm (0.94 x 0.62 X 0.22 inch)