ECOSDetector Extension (50095), 32 outputs

Each one of the 32 outputs provides current up to 100mA max. Since these outputs are conducted as „open collectors", you are able to connect either small light bulbs or LEDs with current limiting resistor directly to it.

The total current of all outputs must not exceed 1.5A! Any DC or AC transformer (15V - 19V) can be used for supply.

Track occupancy and block signals
Outputs can be used to display the state of each single-track section externally (e.g. on the track control panel).

Alternatively, you have the possibility to show each track section´s state on a display via a block signal (red/green).

The transistor outputs of the ECoSDetector Extension module can be easily programmed within the required operational mode via your ECoS command station.

Track control panel
The combination of the ECoSDetector and the Extension module is capable of doing more: e.g. build your own track control panel! To make this possible, you need to connect push buttons or toggle switches to the ECoSDetector´s outputs, which then in turn is able to operate turnouts and routes over the command station.