ASTA Switch kit (6 AC Slow action) MODRATEC

Auxiliary switch kit (6 lever) for Slow action AC motors
The ASTA adds electrical operation to your frame

Adding this switch pack allows electrical operation of up-to 6 slow-motion point motors from an AC power source, allowing you to drive points and signals from your lever frame.
Consists of an assembled board with switches to control up-to 6 stall action point motors.
This module can be added in sets of 6 to equip any size frame.

This Auxiliary Switch Unit may be fitted to a bay of 6 levers of a MODRATEC Lever Frame. It is primarily intended to directly drive slow-motion point motors (switch machines) similar to the Tortoise type.
There are a pair of switches to sense the location of each lever. When a lever is in the normal (back) position, a negative output is generated; when a lever is in the reverse (pulled) position, a positive output is generated.

Screw terminals are provided as follows (9 terminals):
Two terminals to accept an a.c. power input - typically 6-12V a.c.
A common output terminal.
One output terminal corresponding to each lever.
The outputs are rated 100mA (0.1A).

You also require:
A Mounting Kit applicable to the number of levers in the frame(s) to which the Auxiliary Switch Units are to be fitted.
An a.c. power source. This may be looped to multiple Auxiliary Switch Units.

For connection details, please click the "webpage" link at the bottom of this page.

Installation requires a MODRATEC lever frame (Interlocking or Non-Interlocking) and
A MODRATEC auxiliary switch mounting kit (select to suit your frame size.)A 6-12Vac power source (selected to suit your point motors.
The kit is simple to assemble, No soldering is required, screw clamp connectors are pre-fitted to the board.
Includes full instructions.